GDSTIME5015 50mm x 50mm x 15mm 12V Dc Brushless Cooling Fan

I did not buy this for its usual function. I knew when I got it, it would not fit. I bought it for a mini, elongated power supply! I literally had to remove some of its thickness so I could fit the tiny, restricted space inside this specialized power supply. Careful to assure fan blade clearance it installed my Frankenstein adaption. It was quiet and cooled the mini power supply better than the factory original! Satisfied it would be good in all common installations as it went the extra mile for me.

Photo is the old one. Bad bearings, noisy and didn't spin fast enough to move any air. Installing this fan only required splicing the wires and swapping over some insulation bits. Seems to work great, is quiet, and I have a spare since this is a 2-pack!Very happy to bring the charger back into being usable, it has outlasted many others.

Bought this to replace the fan in my TiVo unit that finally quit after ten years. Fit perfectly, installed in seconds and it's off and running. Quiet. Does it's job.

Works great and was a direct fit for the ZD-915 desoldering station. Yes it makes a little normal noise but it doesn't bother me.

I used this fan to replace a dead fan in a Nintendo Gamecube, though I'd suggest buying another fan more meant for the job if you have the option.It doesn't normally fit in a Gamecube. To use it I had to remove the back 50% of all four corners. It took a while as I used a modeling file to do the trick. If I'd had a working dremel at the time, it could have gone a lot faster.It also does not have the correct power connector to work with a Gamecube. I cut the end off of the old fan and this new fan, then soldered the old connector onto the new fan.After those mods, it works great. The old fan was hardly spinning and the Gamecube was overheating, but the new fan keeps it plenty cool.