Penn-Elcom 9106 Rubber Cabinet Foot 2.5 Inch Dia. x 1 Inch H

They are very beefy and strong looking rubber feet. I used them for legs of my speaker cabinets. They work out great no more sliding forward and scorching tiles. They are built well enough. I even observed the same type of rubber feet on a very heavy generator which is still holding up. I think these are a very good investment. The only drawback is that they should have shipped them out with screws and washers, the gas to drive to the hardware store just for washers and screws is hardly fees-able compared to the price of the washers and screws.

too small

I bought eight of these feet to place under some very heavy powered speakers that are sitting on my work desk. They are very well made and do the job. However, I've had them more than a week, and when I enter my office, I smell the smell of a tire shop. Once they air out, I'll be much happier.

I needed to have isolation feet for a large blower I am using for a whole house exhaust fan. These turned out to be the right size and hardness to do the job that I needed. They were also much cheaper than a commercial isolation pad for machinery. Thus job done at a low cost. I was very pleased with the results.

I have a bass guitar speaker cabinet that weighs over 130 pounds, and it originally had much smaller, lighter rubber feet, in a size that attached to the base of the cabinet with only #10 or #12 wood screws. Those original feet really couldn't handle the weight of the cabinet -- when tipped on edge or moved in and out of vehicles, on and off equipment dollies, and dragged around on floors and pavement, the rubber just wasn't substantial enough and those old feet started to crack and fold sideways and generally fall apart.These #9106 rubber feet are definitely a top-notch replacement for this purpose. They take 1/4" mounting hardware (1/4" lag screw plus 1/4" fender or regular washer) and are obviously not going to wear prematurely or crack under rough handling. Four of these are exactly what I had in mind when I noticed the condition of the previous worn-out feet and imagined an ideal replacement set. I don't suppose I will ever need to replace them again.

love these!!! i have used many of these. On the bottom of a very very heavy bed to the bottom of a couch - keeps it from sliding on the wood floor when the kids run and jump on it!!! They worked great on the bottoms of 175 pound front speakers as well. they do not squash under a load and are heavy duty.

I bought 4 of these to replace the original feet for an air compressor. Haven't really used the compressor since I installed the new feet, but they seem to fit well and the price was right.

Great product as always. I buy a few of these every now and then and quality has been consistent over the years.